Rust-Oleum Stops Rust 7701830 Use and Care Manual download pdf (Page 2)

TECHNICAL DATA

STOPS RUST ENAMEL SPRAYS

Form: CS2201

Rev.: 090313

..PRODUCT APPLICATION (cont.)

APPLICATION

Shake can vigorously for one minute after the mixing ball

begins to rattle. If mixing ball fails to rattle DO NOT

STRIKE CAN. Contact Rust-Oleum. Shake often during

use. Hold can 10-16" from the surface and spray in a

steady back-and-forth motion, slightly overlapping each

stroke. Keep the can the same distance from the surface.

Keep the can in motion while spraying. Apply 2 or more

light coats a few minutes apart to avoid runs and sags.

Metallic Sprays are not recommended for outdoor use. Do

not use near open flame.

DRY AND RECOAT

Dry and recoat times are based on 70°F and 50% relative

humidity. Allow more time at cooler temperatures. Dries

tack-free in 2-4 hours, to handle in 5-9 hours, and is fully

dry in 24 hours. Apply a second coat within 1 hour or after

48 hours.

CLEAN UP

Wipe off tip before storing. Clean-up wet paint with xylene

or mineral spirits. Properly discard empty container. Do

not burn or place in home trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object

into can valve opening.

. .

1 2 3

No comments

Rust-Oleum Stops Rust 7701830 Use and Care Manual Page 2